Uline H-9906 Manual De Instalación

H-9906, H-9907
H-9908
MAGNUM HOPPER
BIN ORGANIZER
Post x 4
INSTALLATION OF SELF-LEVELERS AND OPTIONAL CASTERS
Figure 1
Figure 2
Figure 3
PAGE 1 OF 6
1-800-295-5510
uline.com
PARTS
Shelf
(x 6 for H-9906, H-9907)
(x 5 for H-9908)
TO INSTALL SELF-LEVELERS
NOTE: If installing casters, do not install self-levelers.
1. Make sure post is positioned as shown. (See Figure 1)
2. Insert self-leveler into open end of post.
3. Use a rubber mallet/hammer or tap on ground until self-leveler slides
into post.
4. Repeat steps 2 and 3 for other posts.
TO INSTALL OPTIONAL CASTERS
1. Make sure post is positioned as shown. (See Figure 2)
2. Engage the wheel brakes to keep casters from rolling during assembly.
Use a rubber mallet to tap caster stems into posts. (See Figure 2)
INSTRUCTIONS FOR UNIT ASSEMBLY
NOTE: Only five of the six shelves included for H-9908 will be used.
1. Start with the lowest shelf. Snap the interlocking pieces of a
shelf support (wide end down) around the post at the lowest
groove where shelf is to be located. Slide the support up or
down until it snaps onto the groove. Add a shelf support to
the same place on the remaining posts. (See Figure 3)
NOTE: NSF requires food service applications to keep
the lowest shelf at least 6" above the floor.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Shelf Support
(x 24 for H-9906, H-9907)
(x 20 for H-9908)
Self-Leveler x 4
0122 IH-9906