Assembly Instructions; Connection To The Compressed Air Line; Impact Sockets; Operating Instructions - VITO PRO POWER VIKCIP12 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS

Connection to the compressed air line

1. Remove the plastic cap from the compressed air inlet;
2. Insert and tighten the air hose coupling (4) into the air inlet;
3. Attach the coupling to the air hose.

Impact sockets

Never insert or change the impact sockets while the
appliance is running. Always disconnect the appliance
from the compressed air supply before doing this.
1. Fit the impact sockets, making sure it is properly fixed;
2. To remove, pull out the impact socket.

OPERATING INSTRUCTIONS

Start and stop

Check the working pressure and adjust in accordance with
the technical data (Pmax < 6.3 bar).
1. To switch the pneumatic tool on, press the "ON/OFF" switch
(3);
2. To switch off, release the "ON/OFF" switch.

Direction of rotation

Do not change the direction of rotation while the
pneumatic impact wrench is running, it can cause serious
damage to the appliance. Always check the direction of rotation
before you start operating it.
1. To select the direction of rotation, use the forward/reverse
lever (2).
▪ For clockwise rotation, set the lever to the (F) position;
▪ For counter clockwise rotation, set the lever to the (R)
position.

Torque adjustment

Turn the torque control knob (5) to choose the most suitable
torque for the work to be performed.
The ideal operating pressure for the impact wrench is 6.3
bar. At lower pressure the maximum torque will not be
reached.
POSITION
1
LOW, MINIMUM
2
NORMAL
3
STRONG
EXTRA STRONG,
4
MAXIMUM
25

Publicidad

Tabla de contenido
loading

Tabla de contenido