Tabla de contenido
Publicidad
Safety warnings for the use of plasma
cutters
Use and care recommendations
When the machine overheats, the termal protector will activate,
turning the plasma cutter off and turning the LED light ALARM on
Let the plasma cutter cool for 15 minutes and turn it back on.
It is recommended to use a 12 AWG extension cord and connect it to an
INDEPENDENT CHARGING CENTER.
Perform periodic MAINTENANCE to your machine. (Page 11)
2
ENGLISH
Contents
3
To gain the best performance of
3
the tool, prolong the duty life,
make the Warranty valid if
4
necessary, and to avoid hazards
of fatal injuries please read and
understand this Manual before
5
6
Keep this manual for future references.
7
The illustrations in this manual are for reference
8
only. They might be different from the real tool.
11
11
12
13
14
CAUTION
using the tool.
Publicidad
Tabla de contenido
