Cosco Altura Guia Del Usuario página 6

Assembling Your Stroller
Assemble Stroller Frame
7. Hook D-rings onto each side of the
stroller frame.
Install Rear Wheels
NOTE: Hardware for rear wheel
assembly is located on axle.
1. Remove cotter pin and one washer from
axle leaving one washer on the axle.
With the spokes facing out, slide a wheel
onto the axle. Slide on a second washer
(Figure 1).
2. Insert straight side of cotter pin
through hole in axle (Figure 2).
Repeat steps on other rear wheel.
3. Snap hub caps onto both wheels
(Figure 3).
4
7
1
2 Washers
2
3