Installation - Creative ROCK PILLAR SOLAR PATH LIGHT Manual De Instrucciones

Installation

NOTE: Do not use a hammer. If the ground is hard, use water to
soften.
NOTE: Prior to use, set the AUTO/OFF switch located on the
back of the solar box to the AUTO position and allow it to charge
a full sunny day.
□
Refer to the below left illustration, remove top cap and lens assembly (A & B) from the lamp body (C). Pull out the ground stake (D) packed
inside the lamp body (C).
□
Insert the ground stake (D) firmly into the ground at the installation location. If the ground is too hard, soak the ground with water to soften
the ground or drive a metal rod or screwdriver into the ground to create a hole for the ground stake assembly.
□
Place the lamp body (C) over the ground stake (D).
□
Insert the top cap and lens assembly (A & B) into the lamp body (C).
4