Replacing The Drive Belt - Toro 58602 Manual De Instrucciones

Figure 26
1. Z-bend end of cable
5. Install the dirt shield.
Figure 27
1. Nut (4)
2. Dirt shield
g361541
2. Move cable to this hole.
g356418
3. Bolt (4)

Replacing the Drive Belt

Service Interval: Every 50 hours/Yearly (whichever
comes first)
Removing the Belt
1. Remove the dirt shield.
1. Nut (4)
2. Dirt shield
2. Remove the drive belt cover.
1. Bumper
2. Nut (4)
3. Washer (4)
3. Gently pull the engine recoil rope to rotate the
pulley.
19
Figure 28
3. Bolt (4)
Figure 29
4. Bolt (4)
5. Drive belt cover
g356418
g356422