Pottery Barn Queen Instrucciones De Montaje

Farmhouse Bed – Queen, King, California King
Pre-Assembly:
•
Please read all instructions carefully before beginning assembly.
•
For your safety and convenience, assembly by two people is required.
•
Remove all parts and hardware from packaging and identify by comparing to lists
below. Do not discard any contents until assembly is complete to avoid accidentally
discarding any parts or hardware.
Parts Enclosed:
BOX 1
•
(1)Headboard with
Crown pre-attached
•
(1)Footboard
Required for Assembly:
•
Phillips Screwdriver (Not Included)
Assembly Instructions:
1. Determine the desired height of the side rail lips. The lips have been pre-attached
to the lower position (boxspring level) on each side rail. Lips may be adjusted to
the higher position (platform level – makes boxspring optional) by removing the Allen
bolts with the enclosed Allen key (E) and re-attaching lips to the higher set of pre-
drilled holes. Re-tighten bolts with Allen key. Caution: The lips on both side rails
and the center rail (Step 4) must all be affixed at the same height.
Assembly Instructions
BOX 2
•
(2)Side rails
•
(2)Slat rolls
•
Hardware packet containing the following
SIDERAIL LIP
Step 1.Determine side rail lip height
Boxspring level
•
(1)Center rail
•
(6)Support legs
Page 1 of 3
Platform level