Uline H-2887 Manual De Instrucciones

H-2887
RECYCLED PLASTIC
BENCH WITHOUT BACK
TOOLS NEEDED
Power Drill
Bench Base x 3
NOTE: It is important to keep screws loose
throughout assembly. Tighten during step 6.
1. Verify all parts are present before beginning.
2. Place the three bench bases equally spaced on a
flat, level surface.
3. Place a bullnose bench slat on the bench bases.
Align with the pre-drilled holes.
Figure 1
PAGE 1 OF 3
1-800-295-5510
uline.com
7/16" Socket Bit
6' Bullnose Slats x 2
PARTS
6' Bench Slat x 1
ASSEMBLY
4. Loosely attach bench slat to the bench bases with
the 3½" lag screws and washers using the power drill
and 7/16" socket bit (will tighten later in step 6).
(See Figure 1)
5. For the remaining two bench slats, repeat steps
three and four, ensuring second bullnose slat is on
far end of assembly. (See Figure 2)
6. Make sure the bench is square and tighten all lag
screws.
NOTE: H-2565 Mounting hardware sold
separately.
Figure 2
Para Español, vea página 2.
Pour le français, consulter la page 3.
3⁄" Lag Screws x 18 Washers x 18
0621 IH-2887