Mellerware Spring Basic Manual De Instrucciones página 6

ENGLISH
free of dust and other impurities. Boil
water in it and then throw it away.
FILLING WITH WATER
- Note: It is essential to have
before starting the appliance.
- Remove the container from the
base (E).
- Open the lid (A) by lifting the lever
upwards.
- Fill the container, respecting the
capacity indicator (D) between the
MAX/1.7L and MIN/0.5L levels. Note:
indicated maximum, there is a danger
of boiling water being ejected from
the spout.
- Close the lid (A).
- Place the kettle back on the
container securely on top of the base
(E).
USE
- Plug the appliance into the mains.
- Switch the appliance on by pressing
- Once the water is boiling, the
appliance will stop automatically.
- The appliance can be restarted by
using the switch (C), but once the
control device has cooled down, if it
is not restarted, do not force it and
let it cool down.
any time by pressing the switch (C)
on the handle to the "OFF" position.
kettle. Use cold water only. Let the
cold water run for 3 seconds before
WHEN YOU HAVE FINISHED USING
THE APPLIANCE
- Unplug the appliance from the
mains.
- Clean the appliance.
CABLE HOUSING
- This appliance has a housing for the
mains connection cable located at
the bottom of the appliance.
Cleaning
- Disconnect the appliance from the
mains and allow it to cool before
undertaking any cleaning task.
- Clean the electrical equipment and
the mains connection with a damp
cloth and dry. DO NOT IMMERSE IN
WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp
cloth with a few drops of washing-up
liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as
bleach, or abrasive products, for
cleaning the appliance.
- Neither parts of this appliance
are suitable for cleaning in the
dishwasher.
- Then dry all parts before its
assembly and storage.
HOW TO DEAL WITH LIME SCALE
INCRUSTATIONS
- For the appliance to work correctly
it should be kept free of limescale or
magnesium incrustations caused by
the use of hard water.
- To prevent this kind of problem, we
recommend the use of water with low
lime or magnesium mineralisation.
- However, if it is not possible to
use the kind of water recommended
above, you should periodically
remove the lime scale from the
EN