Manual Override - Good Earth Lighting Se1296-Bp2-02Lf1-G Manual De Instrucciones

2
VERIFYING RANGE SETTING
To confirm the set distance, perform a "walk-by test." Walk straight across the
sensor field at the approximate distance set on the RANGE control knob.
IF THE TEST FAILS, try adjusting the sensor head toward the detection zone.
Sensor head can be adjusted either up, down, left, or right.
To Switch To Manual Mode
1
ON
OFF
Default
(Starting Position)
To return to "AUTO" mode: Turn the switch to the OFF position for 10 seconds and then ON.
IMPORTANT
MOTION SENSOR TO RETURN TO CONTROLLING THE FIXTURE THE NEXT DAY.
IMPORTANT
DAY. HOWEVER, THIS PROCESS MUST BE RESET EACH DAY AFTER DUSK TO DAWN FEATURE CYCLES THE PREVIOUS
DAY'S MANUAL OVERRIDE CYCLE OFF.
Customize Settings (cont.)
SECURITY LIGHT SENSOR RANGE SETTINGS
To change the sensitivity of the PIR distance sensing, rotate the
"Range" dial the preferred setting:
10Ft: 10 feet, short range
20Ft: 20 feet, average range
50Ft: 50 feet, long range
Max.: Up to 70 feet, extra long range
Rotate the RANGE control knob to any of the marked presets: 10 Ft. to Max. (~ _ 70 ft.).
When the RANGE control knob is turned to 10 Ft., the detection zone is very tight and
compact, causing the detection sensitivity to be very high. When the RANGE control knob
is turned to Max., the detection zone becomes very broad, resulting in a low sensitivity.

Manual Override

ON
OFF
2-4 Seconds
Switch the power OFF, ON, OFF and then ON within 2-4 seconds.
THE SECURITY LIGHT WILL REMAIN ON UNTIL THE INTERNAL DUSK-TO-DAWN SENSOR
DETECTS THE NEXT DUSK-DAWN CYCLE. ONCE THE LIGHT IS DETECTED, IT WILL ALLOW THE
MANUAL OVERRIDE ALLOWS THE LIGHT TO TURN ON AT ANY TIME, BY OVERRIDING ALL
SENSOR CONTROLS. IT ENABLES THE LIGHT TO ACTIVATE REGARDLESS OF THE TIME OF
to MAX.
ON
OFF
OFF
Walk-By Test
ON
ON
OFF
9