Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
These instructions replace INSTALLING THE TRIGGER HANDLE
HOLDER instructions on page 7 of your operator's manual
INSTALLING THE STORAGE
PANEL AND TRIGGER HANDLE
HOLDER
See Figures 1 - 2.
n Align the holes in the storage panel
with the holes in the handle, as shown.
n Insert a screw through the left hole
(when viewed from front). Install a nut
and tighten securely using a Phillips
screwdriver and 10 mm wrench (not
provided).
n Align the trigger handle holder with the
holes in the handle and panel on the
opposite side, as shown.
n Insert the other screw through the
hole, then install the nut and tighten
securely.
For additional assistance,
please call customer service
at 1-877-617-3501.
Fig. 1
A
B
C
A - Handle
B - Storage panel
C - Phillips screw
D - Nut
In addition to the Phillips screwdriver noted in the operator's manual,
you will also need a 10 mm wrench to complete this assembly.
Fig. 2
D
A
A - Trigger handle holder
B - Screw
C - Nut
B
C
995000737
11-2-18 (REV:01)
Publicidad
Resumen de contenidos para Power Stroke PS803177ES
- Página 2 Estas instrucciones reemplazan las instrucciones del INSTALACIÓN EL PANEL DE ALMACENAMIENTO Y EL SUJETADORE DEL MANGO DEL GATILLO en la página 15 de su manual del operador INSTALACIÓN EL PANEL DE Fig. 1 Fig. 2 ALMACENAMIENTO Y EL SUJETADORE DEL MANGO DEL GATILLO Vea las figuras 1 y 2.