Troubleshooting - Auna Select Drive Manual De Instrucciones

TROUBLESHOOTING

Problem
The device does not
work
No sound
No sound in BT mode
Noise
Potential cause
No power
Wrong input source
selected
The volume is set too
low
Faulty connection
No BT connection
The device has not
been selected as an
output source
Another radio device is
interfering with the BT
connection
System overload
Poor sound quality
Possible solution
Make sure that the
device is plugged in.
Use another device to
check that the socket
is working.
Select the correct
input source
Gradually increase the
volume of the amplifier
and the mobile device
Check all cable
connections
Establish a BT
connection
Select the device as
the output source
Move the device to
another location
and check the BT
connection again
Turn down the output
level of the external
playback device
Check the device again
by selecting a higher
quality source.
EN
27