Table Adjustment; Changing The Saw Balde - Holzmann Maschinen Tk255 Instrucciones De Servicio

17.2.3 Table adjustment

17.2.4 Changing the saw balde

Risk of injury! Wear protective gloves when changing the saw blade.
HOLZMANN MASCHINEN GmbH
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
CAUTION
www.holzmann-maschinen.at
 Remove the saw blade protection cover from the
riving knife.
 Remove the table insert (1)
 Position the saw blade (3) in its uppermost
position.
 Attach the two ring spanners (4+5) to the nut
(7) and flange (6) respectively.
 Loosen the nut (7) (LINGGEWINDE) and remove
it and the flange (6).
 Remove the saw blade (3)
 Clean the arbor, screw and flange if necessary.
 Install the new saw blade
CAUTION
Observe the correct direction of
rotation and dimension of the saw
blade:
Saw bladeØ 254 mm and max.
thickness of 2.8-3.2mm, as well as
mounting diameter of 30 mm.
 Fit the flange and secure the saw blade with the
nut.
 Refit the table insert and the saw blade
protection cover.
1.remove tool box
2.Loosen the following
srews (see pictures)
3. adjust the work table.
Grooves must be parallel
to the saw blade
4. tighten screws again
38
TK255