Beacon Lighting LUCCI PFC56-3B-ABS-US Serie Instrucciones De Instalación página 11

Airfusion Whitehaven Installation Instructions
Remote / Receiver pairing for Ceiling fan 1:
•
Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
•
Install the 3V DC battery in the compartment. Please make sure the polarity of the battery is correct.
(Fig.15)
•
Turn on the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the remote will be ON).
•
Press and hold the "
to the receiver of ceiling fan 1.
If the fan has light kit attached, the light will flash on and off to indicate the paring process is activated.
•
Turn ON and change the speed of the ceiling fan 1 by the remote to check the operation and successful
paring.
•
If pairing has been unsuccessful, repeat these set of steps again.
Remote / Receiver paring for Ceiling fan 2:
•
Turn off the mains supply to the receivers of both ceiling fans 1 and 2.
•
Install the 3V DC battery in the compartment. Please make sure the polarity of the battery is correct.
(Fig.15)
•
Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the remote will be ON).
•
Press and hold the "
to the receiver of ceiling fan 2.
If the fan has light kit attached, the light will flash on and off to indicate the paring process is activated.
• Turn ON and change the speed of ceiling fan 2 by the remote to check the operation and successful
pairing.
• If pairing has been unsuccessful, repeat these set of steps again
10 | P a g e
" button of remote 1 for 3-5 seconds within 30 seconds of switching the power ON
" button of remote 2 for 3-5 seconds within 30 seconds of switching the power ON