Eiko SCRG Instrucciones De Instalación

SAFETY PRECAUTION:
• To prevent personal injury or product damage only licensed electricians should install.
• To avoid electrical shock or component damage, disconnect power before attempting installation or
servicing.
• This product must be installed in accordance with the national electric code (NEC) and all applicable
federal, state and local electric codes and safety standards.
• Disconnect product and allow cooling prior to any further steps.
• Any alteration or modification of this product is expressly forbidden as it may cause serious personal
injury, death, property damage and/or product malfunction.
• To prevent product malfunction and/or electrical shock this product must be properly grounded.
• This luminaire is designed to operate in ambient temperatures ranging from -13°F to 104°F (-25°C to 40°C)
and to be horizontally mounted with the LED board facing downward
INSTALLATION:
Surface-Mounted with J-Box
1. Loosen the screw on the side
of the housing and pull out the
connecting plate.
2. Fix the connecting plate onto
the ceiling and put the wire
through center hole.
3. Buckle the connecting plate into
the clips and connect the wires
as following shows.
4. Slide lamp back into the
connecting plate and fix the
screw that is removed in step 1.
EiKO Global, LLC • 23220 W. 84th St, Shawnee, KS 66227 • (P) 1-800-852-2217 • (F) 1-800-492-8975 • eiko.com
EiKO Canada • 81 King St, Barrie, Ontario L4N 6B5 • (P) 1-705-721-5189 • (F) 1-705-721-7855 • orderdesk@eiko.com
INSTALLATION INSTRUCTIONS
SCRG - Surface Canopy, Round, Garage
1
3
.
2
4