Uline H-6355 Manual Del Usuario

π
H-6355
PIPE WALL UNIT
TOOLS NEEDED
Tape Measure Level
Two Person Assembly
Required
Bottom Upright x 2
Hangrail x 1
1. Install both levelers into underside of bottom uprights.
(See Figure 1A)
NOTE: Screw in leveler as far as it will go, then
back out the same number of turns on both
upright assemblies (approximately half the
length of the screw).
NOTE: Three-way pipe fitting comes loosely
installed on bottom upright. If it falls off during
transit, slide back onto bottom upright.
2. Lay the top and bottom uprights on the floor and
join together.
3. Secure with four long set screws. (See Figure 1B)
PAGE 1 OF 9
1-800-295-5510
uline.com
Screws
Drywall Anchors
PARTS
Top Upright x 2
Flange x 4
ASSEMBLY
Pour le français, consulter les pages 7-9.
Screwdriver
Longset Screw
x 8
Short Pipe x 4 Leveler x 2
Figure 1A
Top Upright
Bottom
Upright
Figure 1B
Tab
Top Upright
Para Español, vea páginas 4-6.
Shelf x 2
Left Shelf Right Shelf
Bracket x 2 Bracket x 2
Upright
Assembly
Leveler
Slot
Bottom
Upright
0121 IH-6355