Uline H-2166 Guía Rápida

H-2166, H-2167
72" PACKING
TABLE LEDGES
Splice x 1 #14 x 3/4" Wood Screw x 14
1. Bolt the side rail to the right side of the top end
attachment with four #14 x 3/4" wood screws.
For steel tops, use four bolts and lock washers.
NOTE: Ensure rounded corners of side rail are
toward the front.
2. Repeat step 1 to install rail for left side.
3. Place two-piece back rail across back and around
outside of side rails. Secure to bench top with six
#14 x 3/4" wood screws and drill holes as needed.
For steel tops, secure to bench top with six bolts,
lock washers and nuts.
PAGE 1 OF 3
1-800-295-5510
uline.com
HARDWARE
1/4" - 20 x 5/8" Bolt x 18
ASSEMBLY
Two-Piece
Back Rail
Front
1/4" Lock Washer x 18
4. Place splice in center of two-piece back rail
between bench top and back rail. Flange should
straddle top of two-piece back rail.
5. Use two bolts, nuts and lock washers at each end to
fasten to back and side rails.
Splice
Para Español, vea página 2.
Pour le français, consulter la page 3.
1/4" - 20 Nut x 10
1/4" - 20 x 5/8" Bolt
#14 x 3/4"
Wood Screw
1120 IH-2166