Atlantis BXLEDTV01 Manual De Usuario

COLORLED
TV LED strips
User manual
BXLEDTV01
Technical information
LED: 5050RGB
LEDs per meter: 30 pcs per meter
Output power: 5W/m
Working voltage: DC5V
Operating distance: 8-10m (without barriers)
Working temperature: -20 ±45°C
Illumination angle: 120°
Dimensions: 53 cm (per strip)
Lumens: 12-15 lm per LED
Installation
1. The LED strips shall be
stuck to the back of the
TV
4. Stick the strip to the
back of the TV
Note: Please, be careful when removing the tape stuck to the back of the strip. It is
recommended to bend the strip slightly and scratch the edge of the tape gently until it
starts to separate from the strip. Do not cut the LED strip, as it would inevitably damage
the product.
How to connect the strips?
First, connect the receiver to the strip with a short 4-pin connector (spare joints).
2. Clean the back of the
TV with a dry cloth
5. Use the USB cable to
connect the strip to the
TV
In the box:
• 6 TV led strips
• 1 remote controller
• 1 infrared receiver (USB cable)
• 4 spare joints
• 5 joint cables
• 6 clips
• 1 user manual
3. Remove the tape stuck
to the back of the strip
6. Remove the remote
control insulation pad
before using it