Safety Instructions; Protecting Yourself; Fuelling; Vibrations - Trueshopping MFS260HT Manual De Montaje

Safety Instructions

Read this manual in full before operating this
machine for the first time. If you have any
questions regarding the operation of the
machine, please contact the manufacturer.
CAUTION! In order to ensure your safety you
must follow the safety, installation and
operation instructions. Any person who uses
this machine should be fully aware with the
potential risks.
! You must be 18 or over to operate this
machine. Children or persons of Diminished
responsibility must not operate this machine.
! The manufacturer shall not be held liable if
the unit is altered outside of the information
printed in this guide.
! Always turn the engine off before
performing any maintenance
! Some components will become hot during
use, specifically – The engine, bump head,
brush cutter blade, the hedge trimmer and
pruning saw.
! WEAR EAR PROTECTION!
! SAFETY BOOTS MUST BE WORN
WHILE OPERATING THE MACHINE!
! WEAR SUITABLE EYE
PROTECTION!
! WARNING, PETROL IS
FLAMMABLE, TAKE
APPROPRIATE CARE!

Protecting yourself

! Do not use this machine in areas with poor
ventilation or indoors, when switched on,
the machine produces Carbon monoxide!
! Do not operate this machine in adverse
weather or in situations where sure footing
is not guaranteed.
! Exercise common sense when operating
this machine, do not operate when under the
influence of alcohol or medication which
may impair judgement and concentration.

FUELLING

! Always switch the engine off before
fuelling.
Open the tank cap slowly to avoid spillage due
to internal pressure. If the unit has recently
been in use, allow to cool down first. Not
allowing the unit to cool could cause the fuel
to ignite.
When replacing the fuel, be careful not to
over fill the tank. Any spillages should be
cleaned up immediately.
After filling ensure that the cap is secured
properly and that it will not work loose while
the machine is switched on.

VIBRATIONS

Vibrations from the machine make it difficult
to hold for long periods of time, this time can
be prolonged by wearing suitable gloves.

Protecting others

! Do not allow anyone to approach the
machine while in use, ensure the working
area is clear of animals and pedestrian
traffic.
! Avoid jamming the blade as this can make
the machine suddenly difficult to control.
4