Ordinary Maintenance - Leonardo Carratu Supershake Libreta De Empleo E Garanzia

Assemblage
Attention! Before beginning to work, be sure
that all the following parts are assembled
correctly.
Telesopic rod - flexible shaft
Grease the internal flexible shaft
connect the rod to the flexible shaft
fix well the two screwn .
Flexible Transmission - engine
connect the flexible shaft to the clutch bell
make sure that this one is well linked to
the engine
Connection gas command cable and
stop
anchor one another the pawls of the hook
up.
insert the two anchored pawls into its own
protection case and close it.
insert the spinets of the stop cable .
Important!: Before using the engine of
brushcutter , remove the rod, the flexible shaft
from the engine and insert the telescopic rod
and the flexible shaft in its place. As for the
attack of the gas cable gas refere to the manual
supplied togther with the engine
Rules for the good use
For an optimal efficiency follow the
following suggestions:
Hook the branches always by forming an
angle of 90° between branch and hook.
(look the figure G and H )
Always Hook the branch in the flexible
part, never where it sprouts
Don't hook big branches and non-flexible
ones (the vibrations will propagate on the
trunk and not on the crown where the tree
bears fruit). You will have a scarce output
of harvest and you will cause breakups
not-covered by guarantee and a useless
stress of the tree. ( Figure F )
English - Carratù Leonardo
(Figure B)
Important! Not applying these rules of
use the Guarantee is invalidated and loses
its right.

Ordinary maintenance

For a satisfactory utilization of the machine is
necessary to give a carefull lubrification to the
machine
Attention!
maintenance, reparation,
with stopped engine
LUBRIFICATION
Flexible transmission ( Figure C )
Important: You have to grease every 15
hours the flexible tree inside the scabbard.
Greasing the Shake model ( Figure D1 )
Important: For shake model Grease
When you have vibrated the branch, move
the hookup. If there are more fruits on the
branch don't go on, move the hookup,
because the fruits
receive vibrations because they are far
from the place where they originate.
When you have hooked the branch don't
use the rod as a lever to bend the
branches, you might cause damages (not
covered by guarantee)
mechanism.
Don't use this machine on breanches
situated at a hight superior to 4.5mt from
the ground. After such height it is used as
a hook to bend
vibrating, the hook will tend to go
downwards and insert into it. In trying to
free the hook from the branch a rift in
steel cursor will be caused and after short
time, when the lesion has completed the
course, the cursor will break.
All the
Unhook the scabbard from the motor or
from the rod,
extract the flexible one
grease it
reassemble everything.
that are there don't
inside the
the branches, while
interventions of
must be effected
the
Pag. 13