Antlion Audio ModMic Uni Manual De Instrucciones

ModMic Uni Installation
Surface Selection
Find a flat spot on the headphones for the 0.5 inch / 12.7mm circle of adhesive. The adhesive will stick to smooth and
mesh surfaces but does not stick well to porous, lacquered, or rubberized surfaces.
1. Put the headphones on to ensure the ModMic will reach the corner of your mouth from the desired mounting point.
2. Thoroughly clean and dry the surface with the included alcohol pad.
Attaching & Orientation
1. Attach a to the top clasp that holds the ModMic's boom.
2. Remove the protective backing from the adhesive.
3. While holding the top clasp, orient the mic boom
angle down so it points towards where your mouth
will be when using your headphones. (This will
reduce the need for additional bends in the
boom after installation—see Figure A).
4. Press the whole mic/clasp down onto the cleaned spot
and hold firmly for 60 seconds. Allow the adhesive to
cure for 1 hour.
5. To reverse the orientation of the boom from the left
earcup to the right, do not remove the boom's screw-on
clasp. Simply re-bend the cable end of the boom
downward in the opposite shape (see Figure B).
Always ensure the cable is pointing downward
to prevent cable breaks.
A
B
L R