Firmware Upgrade - Samsung Dvd-P450 Manual De Instrucciones

C h a p t e r 6
R

Firmware upgrade

Introduction
Samsung will often support the software upgrade to improve the performance of this unit to
status, through Samsung Internet Site (www.samsung.com).
Because the specially new MPEG4 codec continues and it is appearing. What improvemen
made depends on the upgrade software you are using as well as the software that your DV
contained before the upgrade.
How to make an upgrade disc
Write the downloaded file onto a blank CD-R or CD-RW disc, using the following settings:
1
You have to download a new file
through Download Center of
Samsung Internet Site
(www.samsung.com).
2
Write the file to Disc using
CD-RW of your computer.
Upgrade procedure
1
Open the disc tray.
Place the disc on the tray.
Close the tray.
The Firmware upgrade
screen appears.
2
Press the œ œ /√ buttons to
select Total, then press the
ENTER button.
3
Press the number buttons
to select the desired
language.
E F E R E N C E
Firmware upgrade
appears on the display
Firmware upgrade starts
Press 1 for English
Touche 2 pour Français
Drücken Sie 3 für Deutsch
Pulsar 4 para Español
Premere 5 per Italiano
Druk op 6 voor Nederlands
Note
- File System CD-ROM ISO Level
- Character set ISO 9660
- Finalized, single session
- Write speed low
- In the middle of the writing, the tray
automatically. After taking out the dis
please wait for about 2 minutes.
- If the unit was successfully updated,
will turn off and on after closing the t
automatically.
When the unit turns on, this screen w
Note
- If the "Select Menu Language" doesn't
please contact to "Samsung Service Ce
- Do not press any button and unplug the
code during upgrade.
- The upgrade procedure may change, re
the web site (www.samsung.com).
ENG-58