Uline H-7805 Manual De Instrucciones

π
H-7805
MAGNETIC GLASS
DRY ERASE BOARD – 8 x 4'
Two Person Assembly Required
TOOLS NEEDED
1/4", 5/16" and
1/8" Drill Bits
Power Drill
Glass Board x 1
Aluminum Tray x 1
WARNING! Glass dry erase boards are made
of safety glass, but improper handling and
installation may cause serious injury if the
board shatters. Proper installation will require
at least two people.
1. Make sure wall is flat. On drywall and stud walls,
always hit studs (if possible). A minimum of 1/2"
drywall is required. Use correct type anchor and
predrill for the wall type.
PAGE 1 OF 9
1-800-295-5510
uline.com
Phillips
Screwdriver Bit
Chalkline
Board Hardware Kit
Wall Mount Bracket Plastic Anchor x 8
Outer Cap x 8
Wall Mount Bracket x 8
Stud Finder
PARTS
Drywall Anchor x 8
CS Screw x 8
SETUP
IMPORTANT! Do not use unless all screws are tight.
At least every six months, check all screws to be
sure they are tight.
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
Tape Measure
Marker Tray Hardware Kit
Tray Mount x 1
Phillips Tray Screw x 2
Level
0919 IH-7805