Uline H-2999 Manual De Instrucciones
Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
H-2999
6' WOODEN
PICNIC TABLE
TOOLS NEEDED
Drill
Tape Measure
Preassembled Table Top x 1
72" Seat Plank x 4
Figure 1
PAGE 1 OF 6
1-800-295-5510
uline.com
Rubber Mallet
PARTS
59" Pre-Drilled Seat Cross-Member x 2
23⁄" Diagonal Brace x 2
30" Pre-Drilled Table Leg x 4
ASSEMBLY
1/2" Socket Wrench
3½" Carriage Bolt x 8
10" Seat Block x 2
1. Verify all parts are present before beginning.
Hardware is bagged and stapled to the table.
2. Place the pre-drilled seat cross-member on top of
the pre-drilled table legs. Position the legs so the
holes are aligned and the tops of the legs are level
and straight. (See Figure 1)
3. Loosely attach with the 3½" carriage bolts through
the pre-drilled holes using the washers and nuts.
NOTE: It is recommended to use a rubber
mallet to tap bolts through holes.
4. Repeat steps 1-3 for the second side.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
1/8" Drill Bit
Level
2½" Wood Screw x 36
Washer x 8
Nut x 8
0521 IH-2999
Tabla de contenido
Manuales relacionados para Uline H-2999
Resumen de contenidos para Uline H-2999
-
Página 3: Herramientas Necesarias
H-2999 800-295-5510 uline.mx MESA DE MADERA PARA PÍCNIC DE 6' HERRAMIENTAS NECESARIAS Taladro Cinta de Medir Mazo de Caucho Llave de Dado de 1/2" Broca de 1/8" Nivel PARTES 1 Cubierta Preensamblada 2 Travesaños Preperforados de 59" 8 Pernos de Carro 3½"... -
Página 4: Continuación De Ensamble
2. Se recomienda aplicar un sellador o barniz para contenga anti-moho. madera de exteriores que contenga repelente al agua y un estabilizador de rayos ultravioleta. La mesa debe estar seca antes de aplicarlo. 800-295-5510 PAGE 4 OF 6 0521 IH-2999 uline.mx...