Uline H-285 Guia De Inicio Rapido

H-285, H-338,
H-339, H-340
TABLE TOP CUTTER
ROTARY HEAD REPLACEMENT
1. Disassemble one end of the cutter to remove the old
cutting head.
2. 2. Replace with new cutting head and reassemble
cutter. Make sure knife fits between hardened blue
steel blade and aluminum track and doesn't ride
on foam.
3. 3. Loosen cap nuts to adjust knife height for
material thickness. There should be a gap between
the black rubber wheels and aluminum track.
For illustration purposes some features are not shown.
PAGE 1 OF 3
1-800-295-5510
uline.com
The bearings are
glued in place and
not serviceable.
Rotary Knife
Axle
5/16" Flat Washer
Cap Nut
Black Rubber Wheel
Aluminum Track
Hardened Blue Steel Blade
Para Español, vea página 2.
Pour le français, consulter la page 3.
Foam
0521 IH-339