Install The Trolley - CHAMBERLAIN Power Drive 3132E FS2 Manual Del Propietário

ASSEMBLY STEP 2
For Sectional and
One-Piece Doors Only

Install the Trolley

• Attach the trolley threaded shaft to the trolley with
the lock washer and nuts as shown.
• As a temporary stop, insert a screwdriver into the
hole in the front end of the rail.
• Slide the trolley assembly along the rail to the
screwdriver stop.
NOTE: If trolley hits against any nuts on the
rail, the bolts and nuts were attached
from the wrong side and must be
repositioned. Review Assembly Step 1.
ASSEMBLY STEP 2
For Sliding and
Swinging Gates Only
Install the Trolley
• Attach the trolley threaded shaft to the trolley with
the lock washer and nuts as shown.
• Insert a hex bolt into the hole in the front end of
the rail.
• Slide the trolley assembly along the rail until it
rests against the hex bolt (trolley stop).
NOTE: If trolley hits against any nuts on the
rail, the bolts and nuts were attached
from the wrong side and must be
repositioned. Review Assembly Step 1.
Temporary Stop
Screwdriver
Hex Bolt
5/16"-18x7/8"
Hex Bolt
Trolley Stop
Lock Washer
5/16"
Nut
5/16"-18
Lock Washer
5/16"
Outer Nut
5/16"-18
Trolley
Hex Bolt
5/16"-18x7/8"
Lock Washer
5/16"
Outer Nut
5/16"-18
Trolley
11
HARDWARE SHOWN ACTUAL SIZE
Lock Washer
5/16"
Inner Nut
5/16"-18
Trolley
Threaded
Shaft
HARDWARE SHOWN ACTUAL SIZE
Nut
5/16"-18
Inner Nut
5/16"-18
Trolley
Threaded
Shaft
Nut
5/16"-18
Trolley
Lockwasher
5/16"
Cable Pulley
Bracket