RISCO Group RP512MD2400A Instrucciones De Instalación

RISCO Group s Fast Modem enables PSTN communication at 2400 bps for remote programming of the
ProSYS security panel using the Upload/Download software.
Notes:
1. Communication with fast modem is supported by ProSYS Ver. 7 and above and by Upload/download software ver
3.2.3.6 and above.
2. To enable remote Upload/Download with the fast modem the Upload /Download GSM Enable parameter has to be
set to No (Programming Quick Key [5] [5] [15] ).
3. When using the Upload/Download software to establish communication with the fast modem you need to select the
Fast PSTN Modem option.
Installation
1. Install the fast modem into a box using the supplied 2 screws.
2. Wire the modem according to Wiring Diagram.
Note:
The PSTN Fast Modem is connected in parallel to the ProSYS telephone line. The connection to the wall outlet can be
from any one of the following options: to the LINE IN (J12) on the modem (Option A) or to the ProSYS phone connection
LINE IN (see Option B).
DIP Switches Settings
CONFIG Description
DIP 1 Controls the configuration of the tamper terminals
On: Tamper terminals shorted.
Off: Tamper terminals open. Use to connect a tamper switch
DIP 2 Not used
DIP 3 4 Dip switches 3 and 4 determine the local standards to which the modem can
comply with:
DIP 3
OFF
OFF
ON
ON
Programming: Adding the modem to the ProSYS
To enable the operation of the Fast Modem the following steps should be performed:
1. Access the Installer Menu and choose: 7) Accessories > 1) Add Delete Module > 9) More.. > 7)
XMODEM. Set the Type field to Xmodem.
2. Set the X.Modem parameter (Programming Quick Key [5][5][16]) to YES.
Fast PSTN Modem, 2400 BPS
Installation Instructions
DIP 4 Standard
OFF CTR 21 European Union
ON FCC United States
OFF CAN Canada
ON AUS Australia
1
EN
Default
Off
Off
3,4: Off