Remington HC-5200 Guía De Uso Y Cuidado página 22

To attach a comb
■ Hold the comb with its teeth
upward.
■ Slide it onto and along the clipper
blade until the front of the comb
firmly sits against the clipper blade.
To remove the comb
■ Holding the clipper with the blades
facing away from you, firmly push
the comb upward and away from
the blades.
Instructions for hair cutting
■ For even cutting, allow the comb
attachment/blade to cut its way
through the hair. Do not force it
through quickly. If you are cutting
for the first time, start with the
maximum comb attachment.
STEP 1 – Nape
of the neck
■ Set the comb to
3mm or 6mm.
■ Hold the clipper
with the blade
teeth pointing
upwards. Begin
starting at the
centre of the head at the base of
the neck.
■ Slowly lift the clipper, working
upwards and outwards through the
hair, trimming just a little at a time.
STEP 2 – Back
of the head
■ With the comb
set at 12mm or
18mm, cut the
hair at the back
of the head.
22
STEP 3 – Side of the head
■ Set the comb to 3mm or 6mm, trim
sideburns. Then change the setting
to 9mm and continue to cut the top
of the head.
STEP 4 – Top of the head
■ Use the longer length comb
attachment
and set it
to 24mm or
27mm then
cut hair on top
of the head
against the
direction in
which the hair
normally grows.
■ For longer hair on top, use the
longer length comb attachment
(24 – 42mm) to achieve the desired
style.
■ Always work from the back of the
head.
STEP 5 – The
finishing
touches
■ Use the
clipper
without an
attachment
comb
for close
trimming
around the base and sides of the
neck.
■ To produce a clean straight line
at the sideburns, reverse the hair
clipper. Place the reversed clipper at
right angles to the head, tips of the
blades lightly touching the skin and
then work downwards.