Uline H-7021 Manual De Instrucciones
Idiomas disponibles
Idiomas disponibles
H-7021, H-7022
H-7023, H-7024
WIRE WINE RACK
Post x 4
NOTE: For 34" height wire wine racks, there will be 4 shelves and 16 sets of shelf supports.
Figure 1
Figure 2
PAGE 1 OF 6
1-800-295-5510
uline.com
PARTS
Shelf x 8
INSTALLATION OF SELF-LEVELERS
TO INSTALL SELF-LEVELERS
1.
Make sure post is positioned as shown. (See Figure 1)
2. Insert self-leveler into open end of post.
3. Tap on ground until self-leveler slides into post.
4. Repeat steps 2 and 3 for other posts.
ASSEMBLY
1.
Start with the lowest shelf. Snap the interlocking pieces
of a shelf support (wide end down) around the post at
the lowest groove where shelf is to be located. Slide the
Shelf
support up or down until it snaps onto the groove. Add a
Support
shelf support to the same place on the remaining posts.
(See Figure 2)
Pour le français, consulter les pages 5-6.
Shelf Support x 32 Sets
NOTE: NSF requires food service applications to keep
the lowest shelf at least 6" above the floor.
Para Español, vea páginas 3-4.
Self-Leveler x 4
0221 IH-7021
Tabla de contenido
Manuales relacionados para Uline H-7021
Resumen de contenidos para Uline H-7021
-
Página 3: Rack De Alambre Para Vinos
H-7021, H-7022 800-295-5510 H-7023, H-7024 uline.mx RACK DE ALAMBRE PARA VINOS PARTES 4 Postes 8 Repisas 32 Sets de Soportes de Repisa 4 Autoniveladores NOTA: Para los racks de alambre para vinos con altura de 34", el paquete vendrá con 4 repisas y 16 sets de soportes de repisa. -
Página 4: Continuación De Ensamble
4. Determine la altura de la siguiente repisa, deslícela en los soportes, luego agregue y asegure la repisa. (Vea Diagrama 5) 5. Repita el Paso 4 para agregar las repisas restantes. Diagrama 5 800-295-5510 uline.mx PAGE 4 OF 6 0221 IH-7021...