Tork COS-ADP Instrucciones De Instalación

COS-ADP
INSTALLATION INSTRUCTIONS
1. Take all of the wires from the ceiling mounted
occupancy sensor and carefully run them
through the threaded nipple of the adapter.
2. Align the two mounting tabs on the adapter
into the two "L" shaped slots on the occupancy
sensor.
3. Twist the adapter counterclockwise about 1/4"
with respect to the sensor until the two are
comfortably locked together.
4. To remove the adapter (if needed), firmly
grasp the two pieces together and twist the
adapter clockwise about 1/4" until the two
pieces separate. Do not force it.
CAUTION
We recommend that installation be made by a liscensed electrician.
Before wiring and servicing, power to this unit and the equipment it controls must be turned off at the
main panel.
Connect in accordance with national and local electrical codes.
LC-1014 (A)
www.nsiindustries.com