GM 19157544 Manual Del Usuario

GMT900 Commercial Overhead Rack Set
IMPORTANT: READ ALL INSTRUCTIONS BEFORE INSTALLATION.
FOLLOW ALL INSTRUCTIONS CAREFULLY.
NOTE: This Overhead Rack System requires the use of an auxillary
Center High Mounted Stop Lamp (CHMSL). Reference Service Bulletin at
your GM Dealer for details.
Contents:
Item No. Qty. Description
1A 1 Front Rack Corner - Driver's Side
2A 1 Front Rack Corner - Passenger's Side
1B 1 Rear Rack Corner - Driver's Side
2B 1 Rear Rack Corner - Passenger's Side
3 2 Crossbar
4 4 Crossbar End Cap
5 4 Corner Brace
6 4 Rail Nut Assembly
7 8 Hex Bolt, M10x1.5
8 8 Washer, M10
9 12 T-Bolt, M10-1.5
10 12 Lock Nut, M10x1.5
11A 4 Button Head Cap Screw, M6-1.0
11B 4 Socket Head Cap Screw, M6-1.0
12 4 Slide Mount End Cap
13 2 Slide Mount Slide
14 4 Knob
15 4 Tie Down Package
16 2 Centering Aid (Not Shown)
17 1 Pick-Up Box Cargo Management
Accessories Owner's Manual (Not Shown)
Tools Needed
15 mm Socket and Driver
16 mm Socket and Driver
4 mm Hex Wrench
Tape Measure
IMPORTANT: VERIFY THAT ALL PARTS ARE PRESENT.
IMPORTANT: AFTER OVERHEAD RACK IS INSTALLED YOU
WILL NOT BE ABLE TO INSTALL OR REMOVE CARGO
MANAGEMENT SYSTEM TIE DOWNS THAT CAME WITH
YOUR TRUCK FROM EITHER THE FRONT RAIL OR THE TOP
SIDE RAILS. HOWEVER, CONSIDERATIONS CAN BE GIVEN
FOR CONFINED PLACEMENT OF THESE TIE DOWNS PRIOR
TO INSTALLATION OF THIS OVERHEAD RACK AT EITHER OF
THESE LOCATION.
GMT900 Commercial Overhead Rack Set
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 17AU06
WHITE 16 POUND NON-BOND
27SE06 R
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
09OC06
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
I
REAR OVERHEAD RACK
FRONT OVERHEAD RACK
PART NO.
REV 09OC06
INSTALLATION INSTRUCTIONS
AUTH DR
TITLE
GMT900 Commercial Overhead Rack Set
PART NO.
19157544
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19157544
SHEET
1
SHEET
1 15
OF
15
OF