Camair 130515 Manual De Instrucciones

130515 TWO ST GE FILTER
DESCRIPTION
The two stage filter unit is designed to be a
point of use system. It is capable of
removing dirt, water, oil, liquid aerosols
and sub-micron particles.
SPECIFICATIONS
Air Flow: 65 SCFM @ 90 PSIG
Max. Pressure: 150 PSIG
Max. Temperature: 150°F
INSTALLATION
Max. Temperature: 175°F
RISK OF PERSONAL INJURY
RISK OF PROPERTY DAMAGE
Except as otherwise specified by the manu-
facturer, this product is
designed for compressed air service and
use with any other fluid (liquid or gas) is a
misapplication. For example, use with or
injection of certain hazardous gases in the
system (such as oxygen or liquid petroleum
gas) could be harmful to the unit or result in
a combustible condition that may cause fire
or explosion. Manufacturer's warranties are
void in the event of misapplication and
manufacturer assumes no responsibility for
any resulting loss.
Max. Temperature: 175°F
RISK OF PERSONAL INJURY
Release all air pressure from system
before servicing system. Use only speci-
fied parts.
INLET AIR
UNION
FILTER ASSEMBLY*
1/2 NPT
specifically
DRAIN
RECOMMENDED INSTALLATION INSIDE SPRAY BOOTH
54" FROM FLOOR
REPLACEMENT
INDICATOR
OK REPL CE
ELEMENT
130515
1/2 NPT
1st Stage 2nd Stage
Liquid and Liquid aerosols and
dirt removal sub-micron particles
40 microns 0.01 microns
ALTERNATE INSTALLATION
INLET AIR
UNION
130515
FILTER ASSEMBLY**
DRAIN
Service Instruction
SI-6-18-8-A
Replaces SI-6-18-8
SSEMBLY
OPTIONAL 130516
REGULATOR
ASSEMBLY*
OPTIONAL
130500
DESICCANT
DRYER*
*Included with 130522
3-Stage System
OPTIONAL 130516
REGULATOR
ASSEMBLY**
Remove one nipple
**Included with 130523
2-Stage System
OUTLET
AIR