H-6077, H-6078
OUTDOOR DROP BOX
1.
Mark holes where screws are to be located.
2. Drill holes in wall.
3. Mount drop box to wall with four anchors, four
spacers and four screws using a Phillips screwdriver.
NOTE: If mounting directly to stud in wall,
anchors are not needed.
4. Tap anchors into holes with hammer.
5. Insert spacers in between the wall and the back
of the drop box. Screws will insert through holes in
spacers and into wall anchors. (See Figure 1)
NOTE: Spacers need to be used to allow for
the lid of the drop box to open properly when
mounted to wall.
Each key has a 3-digit identification number stamped
on the key. It is recommended that you record this
3-digit number in the event that the keys are misplaced.
NOTE: To order replacement keys (H-3166-KEY),
please contact Uline and provide this number.
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTALLATION
REPLACEMENT KEY INSTRUCTIONS
Figure 1
Screw
000
92268
000
Para Español, vea página 2.
Pour le français, consulter la page 3.
Wall
Anchor
Drilled
Spacer
Hole
3-Digit
Identification Number
(stamped on key)
0321 IH-6077