Mopar 82207621AB Instrucciones De Montaje

1. Installation Preparation -
TAILGATE COVER
Description Qty.
Tailgate Cover 1
Installation Kit 1
2. Tailgate Cover Installation
SCREWS REMOVED FROM
TRUCK TAILGATE
Verify Kit Contents:
Kit Contents:
Installation Instruction Sheet.
FIGURE #1
FIGURE #2
FIGURE #3
FIGURE #4
DODGE RAM TAILGATE COVER
INSTALLATION INSTRUCTIONS
Tools Required:
• #30 TORX DRIVER
(For Mounting the Tailgate Cover)
STEP 1 (FIGURE #1)
Using a #30 TORX Driver, Remove and Save
either Eight (8) or Six (6) screws from Truck
Tailgate (pending tailgate type). Remove only the
Screws Indicated by "X" for all tailgate
configuirations.
STEP 2 (FIGURE #2)
Center the Tailgate Cover on the Truck Tailgate.
Press the Cover Down and Forward into Place.
Line up Holes in Tailgate Cover with Holes in
Truck Tailgate.
STEP 3 (Figure #3 & #4)
Use the Eight (8) or Six (6) Screws, removed in
STEP 1, to Fasten the Tailgate Cover to the
Tailgate with #30 Torx Driver.
Do Not Over-Tighten.
DO NOT USE POWER TOOLS.
Issue Date 6/21/01
Revision 5/10/07
PA0872 Rev. 1
K6858950