SIOUX 1449ESR Instrucciones Y Lista De Piezas

INSTRUCTIONS AND PARTS LIST FOR 1449ESR, 1450ESR, 1451ESR, 1452ESR,
Read and understand "Safety Instructions For Air Tools" and these instructions before
AIR SUPPLY
The efficiency of the tool is dependent on the proper supply of clean dry air at 90 psig (6.2 bar). The use of a line filter, pressure
regulator, and lubricator will insure maximum output and life of tools. Before connecting tool, blow out the air line to remove water
and dirt which may have accumulated.
HOSE AND HOSE CONNECTIONS
Supply hose should be not less than 3/8" (10mm) I.D. Extension hoses should be at least 1/2" (13mm) I.D. Use couplings and
fittings with at least 3/8" (10mm) I.D.
LUBRICATION
Use SIOUX No. 288 air motor oil. An airline lubricator, set to deliver 2 to 4 drops per minute, is recommended. If a lubricator is not
used, add .04 oz. (1.2cc, 12 to 15 drops) of oil into the air inlet twice daily.
Lubricate the gearing every 100 hours of operation with SIOUX No. 289A grease.
GENERAL OPERATION
This tool is equipped with a teasing throttle. By slightly depressing the trigger the chuck will rotate slowly. This is useful for starting
a drill bit without first spotting with a punch. The tool will run at maximum speed when the trigger is fully depressed.
If the gear case is removed or loosened, re-tighten to 35 ft-Ib.
On reversing tools, the direction of spindle rotation is controlled by the reversing button. When the button is depressed,
the spindle rotates counterclockwise. Always depress the button fully to obtain full power. The reversing button on some
models can be locked in the reverse direction by fully depressing and rotating the button clockwise.
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
July 1, 2003
Murphy, North Carolina, USA
Date and place of issues
1454ESR, 1455ESR, 1456ESR DRILLS
(SERIAL "A")
operating this tool.
SOUND AND VIBRATION READINGS
*Sound Pressure
Catalog No. dBA
1449ESR 78.0
1450ESR 78.0
1451ESR 78.0
1452ESR 78.0
1454ESR 78.0
1455ESR 78.0
1456ESR 78.0
*per PN8NTC1
DECLARATION OF CONFORMITY
1449ESR, 1450ESR, 1451ESR, 1452ESR, 1454ESR, 1455ESR, 1456ESR
EN 792 (draft), EN 292 Parts 1&2, ISO 8662, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
Gerald E. Seebeck
President
Sioux Tools Inc.
Name and position of issuer
*Sound Power *Vibration
2
dBA m/s
90.0 Less than 2.5
90.0 Less than 2.5
90.0 Less than 2.5
90.0 Less than 2.5
90.0 Less than 2.5
90.0 Less than 2.5
90.0 Less than 2.5
*per PN8NTC1 *per ISO 8662
Signature of issuer
1
Form ZCE588
Date 2003July23/C
Page 1 of 10
Printed In U.S.A.