Intex 48421 Manual De Usuario

INTEX
Read and follow all safety information and instructions. Keep for future reference. Failure to follow these
Packaging must be read carefully and kept for future reference. See product for additional warnings.
DROWNING HAZARD
• Infants have DROWNED in infant bathtubs.
• NEVER leave the infant unattended.
• Prevent drowning. ALWAYS keep infant within adult's reach.
• NEVER lift this product with infant in it.
• NEVER place this product in water in an adult bathtub.
• ALWAYS keep the drain open in the adult bathtub.
• Infant can drown in as little as 2.5 cm (1") of water.
• ALWAYS bathe your infant using as little water as necessary.
• NEVER allow other children to substitute for adult supervision.
• ALWAYS test water temperature before placing the infant into the product.
• Bathing water temperature shall be between 32 – 38°C (90 – 100°F).
• Discontinue the use of product if it is damaged, broken or disassembled.
• NEVER put an infant to sleep on this product.
• NEVER inflate or deflate with an infant inside the product.
• This is not a toy. Store out of infant's reach.
General
• Assembly and disassembly by adults only.
• For use with children birth to 12 months.
• Ensure this product is compatible with an adult bathtub before use.
• Do not place this product onto another support other than an adult bathtub.
• Recommended bathing time: 10 minutes.
• There are no serviceable parts.
How to Inflate and use
1. Inflate each air chamber with the included hand pump until it is firm to the
touch but not hard. Never over-inflate or use high pressure air to inflate.
2. Insert the stopper into the valve and recess the valve by pushing down
firmly on it.
3. Place the product into an adult bathtub that it is level, stable and firm.
4. Ensure the drain valve cap is securely closed by pushing down firmly on it,
and fill with as little water as necessary.
CAUTION: Never pour hot water directly into this product.
5. Make sure you have all bathing needs within arm's reach before placing the infant in this product.
6. Place the infant's back on the reclined section with the legs between the protruding crotch support.
How to deflate, empty and clean
1. With the infant safely out of the product, pull drain valve cap out.
2. Clean and rinse with mild soap and warm water. Air dry thoroughly before storage.
3. Pull stopper out and squeeze the valve at its base until deflated. Replace stopper back.
Maintenance and storage
1. Check seams and material regularly for tears and holes. If there are any defects discard the product
and replace by a new one.
2. Ensure the product is completely dry before storing. The original packing can be used for storage.
Store the product in a dry room above 5°C (41°F).
Model #: 48421
SAVE THESE INSTRUCTIONS
(280) PORTABLE TRAVEL BABY BATHTUB ENGLISH SIZE: 4.875" X 7.25" PANTONE 295U 10/17/2015
®
OWNER'S MANUAL
Portable Travel Baby Bathtub
IMPORTANT SAFETY RULES
warnings and instructions can result in serious injury or death.
WARNING
INSTRUCTIONS
English
280
280-***-R1-1610