Descargar Imprimir esta página
Progress Lighting P6345 Serie Instrucciones De Montaje E Instalación

Progress Lighting P6345 Serie Instrucciones De Montaje E Instalación

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

***************************************************************************************************************************************************************
WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full
compliance with N.E.C. requirements. If there are any questions, contact a Qualified Electrical Contractor.
CAUTION - All glass is fragile, use care when handling Glass component(s) and or Lamp(s).
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and /or
other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
WARNING - the edge of the wall plate must be sealed to the wall with a permanent waterproof material (latex,sillcone,
urethane, etc.) to comply with U.L. requirements.
NOTE: For more product specifications and information see www.progresslighting.com
***************************************************************************************************************************************************************
BLK
WHT
Turn the knob clockwise for maximum setting and counter-clockwise for minimum setting.
The knobs have been preset at the factory but may need to be adjusted to personal
preference.
- "TIME" controls the length of time the light remains "on" (approx 2 seconds to 80 minutes).
- "SENS" controls the sensitivity to motion (approx detection angle 180°; range 0m to 20m).
- "LUX" controls sensitivity to light. (approx light sensitivity 10Lux when set to min).
•Power source:102 - 145VAC
• Rated load: 360W max (tungsten)
• Rated load: 80W max ( fluorescent )
• Power frequency: 50 / 60Hz
• Rotary angle: 360°
• Water-proof level: IPX5
• Working humidity: < 93% RH
• Working temperature: -20° to +65°C (-4° to 149°F)
Assembly & Installation Instructions
CAUTION:
Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
P6345 SERIES
RED
COMMON
(WHT)
GROUND
(GRN)
GRN
BLK
WHT
WHT
BLK
GRN
COMMON
(WHT)
GROUND
LINE(BLK)
(GRN)
120V ONLY
GRN
BLK
WHT
PAGE 1 of 6
LINE(BLK)
120V ONLY
BLK
WHT
RED
BLK
WHT
RED
WHITE SUPPLY
WHITE OR IDENTIFIED
WIRE
BLACK SUPPLY
WIRE
BARE, OR GREEN
BARE, OR GREEN
GROUND WIRE
FIXTURE GROUND
FROM SUPPLY
OR
BARE, OR GREEN
GROUND WIRE
FROM SUPPLY
SPEC.NO. 93074250
FIXTURE WIRE
UL LISTED
WIRE NUTS
PLAIN OR BLACK
FIXTURE WIRE
WIRE
GREEN GROUND
SCREW
01-09-2016
loading

Resumen de contenidos para Progress Lighting P6345 Serie

  • Página 5 Instrucciones de montaje e instalación PRECAUCIÓN: lea con cuidado las instrucciones y desconecte la energía eléctrica en el panel de disyuntores principal antes de iniciar la instalación. SERIE P6345 *************************************************************************************************************************************************************** ADVERTENCIA: si se usa algún dispositivo de control especial con este accesorio, siga con cuidado las instrucciones para garantizar el cumplimiento total con los requisitos de N.E.C.
  • Página 6 Elección de la ubicación: La unidad se ha diseñado para montarse en una superficie vertical de 1,8 a 2,4 metros (de 6 a 8 pies) por encima del suelo para obtener un desempeño óptimo. Siempre que sea posible, coloque la unidad de modo que su zona de cobertura esté alejada de fuentes de calor o superficies reflectantes, como por ejemplo rejillas de calefacción, aparatos de aire acondicionado, árboles de gran tamaño o piscinas de agua.
  • Página 7 REVISION TRACKING HISTORY DESCRIPTION DATE INIT. 04/05/16 MDB 160405005 CREATED NEW INSTRUCTION SHEET...

Este manual también es adecuado para:

P6345-28