Tripp-Lite SR14 Manual Del Propietário

SmartRack
Panel-Mount
Three-Fan Accessory
IMPORTANT SAFETY INSTRUCTIONS.
and use an assistant to lift and stabilize the unit during installation. Do not connect the fan panel to
power until it has been properly installed in a rack enclosure.
Rail
Clip Nuts
Figure 1
Installation Procedures
Parts List:
SR14 Panel-Mount Three-Fan Accessory (1)
#10-32 Clip Nuts—Tinnerman # C31758-1032-3B (4)
#10-32 x 1/2 Philips-Head Screws (4)
Tools Required: Phillips-Head Screwdriver
Note: The included clip nuts provide mounting points on
19-in. rackmount equipment rails. Clip nuts have a front
(screwhead) side. Before securing clip nuts to the rack,
determine which way they should face for ease of access to
the screwhead during component installation. Clip nuts may
be removed from rack rails by placing the tip of a fl at-blade
screwdriver or knife under the tab on the front and prying
up to free the retainer ring from the rail (see Figure 1).
1. Select the position at which the fan panel will be installed
in the rack enclosure.
2. Install one clip nut into the top hole of the selected
position
3. Install a second clip nut on the same rail, six holes down
(see Figure 2).
4. Measure from the bottom of the vertical rail to the top
clip nut. Install remaining clip nuts on the opposite
vertical rail at the measured height.
5. Using an assistant, attach the fan panel to the clip nuts with
the included 10-32 x 1/2 Phillips-head screws (see Figure
3). Plug the power cord into a grounded 120V outlet.
Copyright ©2007 Tripp Lite. All rights reserved. SmartRack™ is a trademark of Tripp Lite.
Owner's Manual
Model: SR14
Use this hole
Rail
Figure 2
™
To avoid injury, follow installation steps in sequence
.5"
.625"
.625"
.5"
.625"
.625"
.5"
10-32 x 1/2
Philips-Head Screws
.625"
.625"
.5"
Warranty Registration
Visit www.tripplite.com/warranty today to register the
warranty for your new Tripp Lite product. You'll be
automatically entered into a drawing for a chance to win a
FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply.
See website for details.
Tripp Lite follows a policy of continuous improvement.
Product specifi cations are subject to change without notice.
1111 W. 35th Street
Chicago, IL 60609 USA
Customer Support: (773) 869-1234
www.tripplite.com
Clip Nuts
Power Cord
Figure 3
Rails