Microlife AD-1024A Manual De Utilización

Using the AC power adapter
You may also operate this monitor using an
AC adapter. Use only the included AC
adapter to avoid damaging the unit.
a) Ensure that the AC adapter and cable are
not damaged.
b) Plug the adapter cable into the AC
adapter port on the right side of monitor.
c) Plug the AC adapter into a 110 V power
socket (U.S. or Canada).
d) Test that power is available by switching
the screen lock located on the right side of
the monitor off and on. The screen display
will be visible after pressing START/STOP if
the power is available.
Note:
• No power is taken from the batteries
while the AC adapter is connected to the
instrument.
• If the power is interrupted during a
measurement (e.g., by removal of the
adapter from the wall socket), the instru-
ment must be reset by removing the plug
from the instrument.