Health Zenith 598-1041-04 Manual De Instrucciones

Motion Sensing
Cast Aluminum
Lantern for
Canadian Tire
Features
• Light comes on when motion is detected.
• Automatically turns light off.
• Dusk Accent lighting.
• Photocell keeps the light off during day-
light hours.
This package includes:
• Lantern
• Easy to use universal mounting bracket
(X-Bar)
• Mounting hardware
• Wire nuts
Requirements
• The Light Control requires 120 volts AC.
• If you want to use Manual Mode, the con-
trol must be wired through a switch.
• Some codes require installation by a
qualified electrician.
OPERATION
Mode: On-Time
Test 5 Sec
Auto 1, 5 or 10 Min
Manual To Dawn*
Accent 3,6 Hr, to Dawn
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
minutes for the circuitry to calibrate.
© 2004 DESA Specialty Products™
Works: Day Night
x x
x
x
x
1
/
Set the ON-TIME switch
on the bottom of the cover
plate to TEST.
Set ON-TIME switch to 1,
5, or 10 minutes.
MANUAL MODE
Manual mode only works at
night because daylight returns
the sensor to AUTO.
Flip the light switch off for
one second then back on to
toggle between AUTO and
MANUAL MODE.
Manual mode works only with
the ON-TIME switch in the 1,
5, or 10 position.
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes,
turn the power off for one minute, then back on.
After the calibration time the control will be in
the AUTO mode.
Dual Brite
Light comes on half bright for selected time
2
after dusk (3 hr., 6 hr., until dawn). If motion
is sensed, the light turns on full bright for the
ON-TIME (1, 5, or 10 minutes) then returns
to dim mode.
TEST
TEST 1 5 10 MIN
AUTO
TEST 1 5 10 MIN
1 Second
OFF then ...
... back on.
ON-TIME
Switch at 1,
5, or 10
minutes
Flip light
switch off for
one second
then back on*
™ Dimmer Control
598-1041-04