Idiomas disponibles
  • ES

Idiomas disponibles

Enlaces rápidos

TRCV4 – RADIO-CONTROLLED MOTORCYCLE
1. Introduction & Features
Thank you for buying the TRCV4! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
• Keep the device away from children under three years of age.
• Do not use the TRCV4 on the road, in crowded places or in water / humid environments.
• Do not put the TRCV4 near heating devices.
• Remove the batteries from the motorcycle and the remote control after use.
3. Remote Control
Fig.1
1. Forward (accelerator handle)
2. Stop
3. Left turn (steering handle)
4. Right Turn
5. On/off switch
6. (at the rear:) battery compartment.
4. Preparations
1. Charge the 7.2V battery pack beforehand.
2. Install the battery pack into the motorcycle (bottom side). Turn the locking pads to fix/release the battery pack.
3. Install the battery into the remote control (fig.1 #6).
4. Switch the remote control on (fig.1 #5).
Fig.2
5. Switch the motorcycle on (fig. 2).
5. Use
• Make sure the surface on which you are going to ride is fairly smooth.
• Hold the motorcycle upright, press the accelerator forward and release the motorcycle after a few seconds.
• Alternately, put the motorcycle on the ground and press forward until it starts moving and stands up of its own.
• To stop the motorcycle, simply release the accelerator handle or pull it back to brake.
• Set the power switches of both the motorcycle and the remote control to "OFF" to stop using the device.
• Remove the batteries from the motorcycle and the remote control after use.
6. Troubleshooting
If the device is not operating properly:
• Are the batteries OK/charged?
• Are both the motorcycle and the remote control switched on?
• Is any nearby device operating on the same frequency (27MHz)?
• Are the wheels of the motorcycle not blocked?
TRCV4
1
VELLEMAN
Tabla de contenido
loading

Resumen de contenidos para Velleman TRCV4

  • Página 5: Spécifications Techniques

    7. Tuyaux • Quand il y a un tremplin et vous voulez faire sauter votre TRCV4, faites que la moto y arrive à pleine allure. • Pour exécuter une culbute en avant, cherchez un seuil à pente assez forte et faites que vous y arrivez à...
  • Página 6: Preparaciones

    • Para parar la moto, suelte simplemente la palanca de aceleración o tire de la palanca hacia atrás para frenar. • Coloque los interruptores de la moto y del mando a distancia en “OFF” si no va a utilizar la TRCV4 durante algún tiempo.

Tabla de contenido