Uline H-464 Guia De Inicio Rapido

H-464, H-465
HEAVY DUTY
TAPE DISPENSER
1. Place dispenser on flat surface. Push tape roll fully onto
tape wheel. Be sure tape unwinds with sticky side down.
(See Figure 1)
2. Unroll 5-6 inches of tape (sticky side down) and thread
between rubber roller and metal loading gate. (See
Figure 2)
3. Pull tape over rubber roller allowing tape to unroll freely
off tape wheel. (See Figure 3) To unwind tension, see
Figure 4.
Figure 1
A
PAGE 1 OF 3
1-800-295-5510
uline.com
Plastic Wipedown
Blade
Rubber Roller
Tape Cutting
Blade
Adhesive Side
Of Tape Down
Metal Loading Gate
INSTRUCTIONS
Figure 2
PARTS
Adjustable
Unwind Tension
Knob
4. Start desired depth on the side of the box.
(See Figure 5, A)
5. Glide dispenser along the carton seam - smoothing
roller automatically presses tape to the package.
(See Figure 5, B)
6. Continue down the opposite end to desired length.
In one motion, tilt dispenser forward so tape pressing
wiper stops rolling tape, serrated blade cuts tape and
wiper smoothes the tape end. (See Figure 5, C)
B
Para Español, vea página 2.
Pour le français, consulter les page 3.
Figure 3 Figure 4
Figure 5
C
0721 IH-464