Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

1 What is in the box
Note
Make sure you have all these items in
the box. Contact your dealer for any
missing or damaged items.
Plastic wall anchor x 2
Screw mount x 2
Movable mount x 1
Fixing mount x 1
Fixing knob x 1
M5 mounting screw x 2
M6 mounting screw x 2
Long screw x 2
Note
Two types of mounting screws (M5 and
M6) are supplied but only one type
is needed. Check the design of your
speaker holes fi rst.
Note
The items described are the quantity
supplied per unit pack. For SQB1111
and SQB1131, 2 packs and 5 packs are
supplied in the package respectively.
A5_SQB1111_indesign_updatedDec12.indd
A5_SQB1111_indesign_updatedDec12.indd
Tools that are needed but not
included:
Drill
9/64" drill bit
Philips head screwdriver
Hammer
2 Assembly
instructions
1
Drill two holes in the wall. The
size of the holes need to be
slightly smaller than the plastic wall
anchors. The distance between
the two holes must be the same
distance as the two holes on the
fi xing mount.
2
Punch the plastic wall anchors into
the two holes on the wall.
3
Ensure that the two holes on the
fi xing mount point at the plastic
wall anchors.
4
Put the long screws through the
fi xing mount into the plastic wall
anchors.
There are two ways to assemble
the rest of your items. Check the
design of the speaker holes and
select a suitable way to fi x your
speaker.
For speakers with two holes at
the back:
1
1
5
Ensure that the two outside holes
of the movable mount point at the
speaker holes.
6
Put two M5 (or M6) mounting
screws through the two outside
holes of the movable mount into
the speaker.
7
Ensure the ends of the mounting
screws are fi xed tightly into the
speaker. Place the fi xing knob on
top. Adjust the movable mount
to the desired angle. Then tighten
the lock of the fi xing knob until it
stops.
Note
In the above case, the screw mount
is not needed.
For speakers with one hole at
the back:
8
Ensure that the screw mount
points at the central hole of the
movable mount.
9
Put the M5 (or M6) mounting
screw through the central hole of
the movable mount into the screw
mount.
10
Ensure the head of the mount-
ing screw is fi xed tightly into the
speaker. Place the fi xing knob on
top. Adjust the movable mount
to the desire angle. Then tighten
the lock of the fi xing knob until it
stops.
SQB1111 / SQB1131
2008-12-17
2008-12-17
1
2:49:34 PM
2:49:34 PM

Publicidad

loading

Resumen de contenidos para Philips SQB1111/17

  • Página 1 • Drill • 9/64” drill bit Note • Philips head screwdriver • • Make sure you have all these items in Hammer the box. Contact your dealer for any missing or damaged items. Ensure that the two outside holes...
  • Página 2 Contenido de la caja Nota • En la descripción de los elementos aparece la cantidad que se incluye por Nota paquete. Para los modelos SQB1111 y SQB1131, se incluyen 2 y 5 paquetes • Asegúrese de que la caja incluye todos respectivamente en el embalaje.

Este manual también es adecuado para:

Sqb1131/17