Graco MAGNUM dx Manual De Instrucciones

Instructions
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
dx Sprayer Assembly
1. Lay sprayer on its back on the floor.
2. Install front legs (B) on frame (A), by
sliding holes in legs over screws (C).
3. Place nut (D) over end of each
screw.
4. Place sprayer upright.
5. Tighten nuts (D) securely.
6. If sprayer is not level, loosen
nuts (D) on one leg and adjust
leg up or down as needed.
7. Tighten nuts (D).
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2006, Graco Inc. is registered to I.S. EN ISO 9001
C
A
D
311541A
A
C
B
D
ti8045a