Isotek EVO3 TITAN ONE Instrucciones De La Instalación

Isotek EVO3 TITAN ONE Instrucciones De La Instalación

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 4

Enlaces rápidos

EVO3 TITAN ONE
INSTALLATION INSTRUCTIONS
SAFETY FIRST
PLEASE READ THE FOLLOWING INSTRUCTIONS BEFORE INSTALLATION
DO NOT expose this product to dripping or splashing and no objects filled with liquids, such as vases,
shall be placed on the apparatus. If liquid enters the chassis immediately turn off and unplug from the wall socket.
DO NOT impede ventilation by covering the ventilation openings with items, such as newspapers,
table-cloths, curtains, etc.;
DO NOT expose this product to naked flame sources, such as lighted candles, these should not be placed
on the apparatus;
MAKE SURE that this appliance (CLASS 1) is connected to a mains outlet socket with protective earth.
PLEASE NOTE that the mains plug is used as the disconnect device and must remain readily operable.
OUTPUT SOCKETS
ADDITIONAL INFORMATION ON FUSING AND RATINGS
A
The output socket marked 'A' is designed for use with high current electronics, for example, power amplifiers
mono block power amplfiers, integrated amplifiers, sub woofers and active loadspeakers.
The output socket marked 'B' is designed to connect additional Titan One or Genesis One units together in a daisy
B
chain configuration so that only one master input power cable is required to power the first unit. This output socket
is rated at 3680W.
A
Power on/off switch
B
SERVICE & REPAIR
NO USER SERVICEABLE PARTS INSIDE
Should the unit fail, or cease to function, or function in a manner which seems unusual, please immediately turn off
and unplug from the mains supply.
Send an email to: support@isoteksystems.com
IEC input

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Isotek EVO3 TITAN ONE

  • Página 1 EVO3 TITAN ONE INSTALLATION INSTRUCTIONS  SAFETY FIRST PLEASE READ THE FOLLOWING INSTRUCTIONS BEFORE INSTALLATION DO NOT expose this product to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. If liquid enters the chassis immediately turn off and unplug from the wall socket.
  • Página 2: Recommandations De Securite

    EVO3 TITAN ONE INSTRUCTIONS D’INSTALLER  RECOMMANDATIONS DE SECURITE VEUILLEZ LIRE CES INSTRUCTIONS AVANT D'INSTALLER L'APPAREIL N'EXPOSEZ PAS ce produit aux éclaboussures de liquide ni à l'humidité. Ne posez pas des récipients contenant des liquides sur ou à proximité de l'appareil. Si un liquide parvenait à entrer dans le châssis, débranchez l'appareil immédiatement de la prise murale.
  • Página 3: Sicherheitshinweise

    EVO3 TITAN ONE HINWEISE ZUR INSTALLATION  SICHERHEITSHINWEISE BITTE LESEN SIE VOR DEM ANSCHLUSS DES GERÄTS DIE FOLGENDEN HINWEISE SCHÜTZEN SIE das Gerät vor Spritzwasser und stellen Sie keine mit Flüssigkeit gefüllten Gegenstände wie Vasen in die Nähe des Geräts. Sollte Flüssigkeit ins Gerät gelangen, ziehen Sie sofort den Netzstecker aus der Steck- dose.
  • Página 4: Tomas De Salida

    EVO3 TITAN ONE INSTRUCCIONES DE LA INSTALACIÓN  NOTAS SOBRE SEGURIDAD POR FAVOR, LEA ESTAS INSTRUCCIONES ANTES DE LA INSTALACIÓN DEL PRODUCTO DO exponga este producto a posibles salpicaduras de líquidos y no sitúe recipientes que contengan líquidos cerca del aparato. Si entrara algún líquido dentro del chasis, desenchúfelo de la toma de red inmediatamente.
  • Página 5 EVO3 TITAN ONE 安装说明 安全措施  安装之前,请阅读以下说明: 1.严禁沾水! 本设备不允许有液体滴入、 溅入! 请勿将液体容器 (如花瓶) 放置在设备周围。 如若进水, 立即从墙壁插座上拔下电源。 2.严禁阻碍散热! 本设备的散热通风口不要用物品 (如报纸、 桌布、 窗帘等) 覆盖。 3.严禁在设备周围放置明火 (如点燃的蜡烛) 。 4.确保将本设备 (CLASS1) 连接至带有接地保护的主电源输出插座。 5.请注意, 必须保证本设备的电源插头作为断电手段、 随时可用。 输出插座 关于保险丝和插座规格的其它信息 标有“A”的输出插座可被用于大电流电子设备,例如:功率放大器、单声道功放、合并式放大器、低音炮、以及有 源扬声器等。 标有“B”的输出插座,用于串联下一个 Titan One 或 Genesis One 输出插座。这样一来,整个系统只需一根主输入...
  • Página 6 EVO3 TITAN ONE  ‘A’ Titan One Genesis One “B”. 3680 Power on/off switch IEC input : support@isoteksystems.com...
  • Página 7: Подключение К Сети

    EVO3 TITAN ONE INSTALLATION INSTRUCTIONS UNPACK РАСПАКОВКА DEBALLAGE / AUFPACKEN / DESEMBALAR / 15kg EVO3 Premier 1.5m PLUG IN ПОДКЛЮЧЕНИЕ К СЕТИ BRANCHEMENT SECTEUR / EINSTECKEN CONECTAR 3680w SUB WOOFER INPUT PLACEMENT УСТАНОВКА PLACEMENT / POSITIONIEREN / UBICACIÓN / A = MIN 3cm...
  • Página 8 EVO3 TITAN ONE INSTALLATION INSTRUCTIONS TURN ON ВКЛЮЧЕНИЕ MISE EN ROUTE / ANSCHALTEN / ENCENDER / CONTROLS РАВЛЕНИЕ PILOTAGE DES FONCTIONNALITES / KONTROLL-KNOPF / CONTROLES / Power on LED UPGRADE ОБНОВЛЕНИЕ MISE A JOUR / UPGRADE / ACTUALIZAR / EVO3 PREMIER...

Tabla de contenido