AVS Bugflector Instrucciones De Instalación

Bugflector
For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Important Safety Information
• CAUTION - Before driving, ensure that the hood shield is properly secured to vehicle.
• Do not use automatic "brush-style" car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
Contents
NOTE: Actual product may vary from illustration.
Hood shield
Tools Required
Preparation Before Painting / Installation
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash and dry your vehicle to remove any debris and/or dirt from the installation area.
Installation Steps
Open hood. Locate (2) square holes on the underside of hood
and clean this area. Remove and discard (2) plastic fasteners
located on the hood seals.
1
Installation Instructions
- Bugflector II
®
Car Wash Supplies Clean Towel
NOTE: Actual application may vary slightly from illustrations.
- Carflector
®
Bump On Hood Insert
x4 x2
Phillips
screwdriver
Press (2) hood inserts into the (2) square holes. If
necessary use tape to hold them firmly in place.
2
Page 1 of 2
I - Sheet Number BF30 Rev.B
®
Grommet Screws
x2 x2
Tape
Fastener
x2