Desa PP100 Instrucciones De Instalación

InstructIons For InstallIng PP100
Carton Contents
• 1 Blower Accessory
• 4 #10 Screws
• 2 #8 Screws
• 1 Lower Baffle
NOTICE: Only install this blower
in the heater models listed on the
blower carton. The thermostat
function will not work correctly
in other heater models.
NOTICE: If wall mounted, discon-
nect heater from gas supply and
remove from wall before install-
ing blower accessory. Contact a
qualified service person to do
this. Follow all local codes.
WARNING: Blower acces-
sory must be grounded. Blower
comes with a three-prong,
grounding plug as shown in Fig-
ure 1. The plug is your protection
against electrical shock. Plug
it into a standard, three-hole,
grounded, outlet. If cord needs
replacing, use only a cord with a
three-prong, grounding plug.
CAUTION: Label all wires
prior to disconnection when
servicing controls. Wiring errors
can cause improper and danger-
ous operation.
ATTAChING BLOWER ACCEssORy
1. Remove front panel from heater by remov-
ing four painted screws holding front panel
to cabinet.
2. Remove knock out from cabinet back
panel (see Figure 2).
3. To remove knockout plate from baffle, snip
two small tabs in front of plate. Move plate
up and down as shown in Figure 3 until tabs
in back snap apart. Discard knockout.
thermostat Blower accessory
save this manual for future reference.
For more information, visit www.desatech.com
4. Locate new lower baffle from packaging.
Attach to upper baffle with 2 #10 screws
as shown in Figure 3.
5. Thread power cord through knock out
hole in back panel.
CAUTION: Do not plug power
cord into electrical outlet until
installation is complete.
Grounded Outlet
Grounding Plug
Figure 1 - Grounding Plug
Knock Out
Back
Panel
Figure 2 - Rear of Heater, Screws and
Blower Location
Upper
Baffle
Lower
Baffle
Figure 3 - Remove Knockout and
Attaching Lower Baffle
Blower Location