TOW READY 63130 Guia De Inicio Rapido

NOTE: See figure 5 for the minimum and maximum size cross-bars that this bike rack can be used.
"A"
VEHICLE FORWARD
ASSEMBLY INSTRUCTIONS:
1. Assemble the Wheel Trays together using two hex
bolts, flat washers, and hex nuts. (Figure 1)
Do NOT cover load rating label.
2. Install the plastic End Caps to wheel trays.
3. Attach the bike Support Arm Bracket to the wheel
trays using two hex bolts, flat washers, and hex
nuts. (Figure 3)
NOTE: The attachment location "A" varies by bike.
Use your bike as a guide to locate the Support Arm
bracket so that the angle between the Support Arm
and bike tube is approximately 90 degrees and that
the front wheel of your bike is locate as shown - see
figure 2.
4. Attach the bike rack assembly to vehicle roof rack
FRONT cross-bar using the U-bolts and plastic
knobs. (Figure 4)
NOTE: There are two different size U-bolts
provided. The size of U-bolt required depends on
the width of the vehicle Cross-bar. (Figure 5)
Cequent Towing Products - Plymouth, MI
Technical Service: (888) 521-0510
www.towready.com
ITEM:
DESCRIPTION:
90
Support Arm
28" Min.
Figure 2
63130
ONE PLACE ROOF TOP BIKE CARRIER
Hex Bolt
Support Arm
Bracket
Cross-bar
End cap
Front Cross-bar
1-3/8" Max.
Cross-bar
3-1/4" Max.
Page 1 of 9
Flat Washer
Hex Nut
Figure 1
Figure 3
Plastic Knob
Figure 4
5/8" Min.
1-1/2" Min.
Figure 5
63130N 5-2-07 Rev A