Yakima TRACKS Manual De Instrucciones

Tracks
Read yellow caution
page before you begin.
Remove both
tracks.
next, drill
9/32" hole.
1030988F-1/9
TOOLS REQUIRED:
adjustable end wrench
1/2" wrench
1/8" Allen wrench
center punch
hammer
electric drill
1/8" drill bit
9/32" drill bit
touch-up paint
Clean
vehicle's
roof before
you begin.
Punch center of marks
to prepare for drilling.
seal edges
of holes with
enamel base
paint. allow
Carefully blow
to dry.
away debris.
Place both tracks on the
roof. Carefully select their
locations, making sure
they are aligned with each
other and symmetrical on
the vehicle. Carefully hold
the tracks in place with
masking tape.
Do not DRILL DeePeR tHan 1/4". use a drill
stop to prevent drilling through vehicle's interior
liner. If you do not have a stop, use tape and
mark bit 1/4" from tip.
attach
soft rubber
washers onto
Plusnuts®.
note: Washer
should be
flat against
Plusnut® head.
If you will be installing tracks on several vehicles,
call for information on industrial grade installation tools.
YAKIMA CUSTOMER SERVICE: 888-925-4621
outline rear holes through
both tracks.
track base is loose and can slide.
Be sure it is aligned to track.
For both tracks, first,
drill 1/8" pilot holes.
Wear goggles
when drilling!
attach Plusnut®
attach nut with
and washer
washer onto
to tool
Plusnut® tool.
as shown.
I n s t R u C t I o n P a R t # 1 0 3 0 9 8 8 R e v . F
ATTENTION INSTALLERS: