BUCK COMMANDER AGC-408 Manual De Instrucciones

WARNING
A child or adult can tip the cabinet and be killed or
seriously injured.
Failure to secure the cabinet as shown in these
instructions can result in death or serious injury to
children and adults.
Children should not play with or around the
cabinet at any time.
Record the serial number from the back of the cabinet.
Keep keys in a secure place away from children.
Do not store this document in the cabinet
Tools Required: Phillips screwdriver, 7/16" wrench, drill, 3/16" drill bit,
tape measure
PARTS INCLUDED
Shelf
Center Partition
Barrel Rest (2)
Scope Standoff (2)
Foam Liner Kit
Plastic Plug (2)
®
Instructions
AGC-408
Tip Over Hazard
Small Washer (4)
Screw (10)
Bow Hanger (4)
Nut and Bolt (8)
Lag Screw and
Large Washer (4)
Foam Arrow
Holders (2)
Shelf Foam
Bottom Foam (2)
CABINET CONFIGURATION
CENTER PARTITION ASSEMBLY
INSTALL THE CENTER PARTITION AND SHELF BEFORE
MOUNTING THE CABINET TO A WALL AND FLOOR.
Lay the cabinet on its back on a protective surface.
Position the center partition carefully to align the holes on the bo om.
front ange of the center partition should point to the right
of mounting holes in the cabinet. Use the le set of mounting holes.
ensure that the partition is in the exact center of the cabinet.
Install and tighten the 2 nuts and bolts as shown.
Your nal assembled cabinet will
have bow storage on the le side
and gun storage on the right side.
Before you install the cabinet to a wall
and oor, install the shelf and center
partition, barrel rests, foam lining and
bow hangers.
ere are two sets
is will
40305-1401
e
1
21